User's Manual

10
•
Getting Started DSP700 Series Wireless Wheel Alignment Sensors
1. Insert the battery pack with the factory label on top.
2. Replace the battery pack cover.
1.7 DSP700 Series Sensors Hot Swap Battery Pack Replacement
Instructions
This procedure provides instructions for hot swapping the battery pack in
DSP700 series sensors during an alignment procedure. Hot swapping the battery will
recall/retain the information in the sensor if the alignment procedure is still in progress.
If the sensor was compensated prior to swapping the battery, the sensor will indicate it by
illuminating the middle compensation indicator while flashing the two outer compensation
indicators.
1. Remove and replace the battery as described above.
2. Restore the sensor to its original position.
The hot swap procedure should be completed in the time period of approximately 1 minute.
1.8 User Battery Replacement:
The batteries in the battery pack may be replaced. When replacing, use six rechargeable
2700 mAH AA NiMH batteries. Replace all batteries in the battery pack at the same time,
with the same type of battery.
CAUTION: Be sure to check the battery placement, as reversing polarity
may cause irreparable damage to the battery pack.
CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. DISPOSE OF USED BATTERIES
ACCORDING TO INSTRUCTIONS.
CAUTION: INCORRECT BATTERY PLACEMENT CAN RESULT IN
ARCS/SPARKS.