User's Manual

DSP700 Series Wireless Wheel Alignment Sensors Getting Started
•
7
1.5 Sensor Battery Packs
Each sensor contains a 3.6 VDC 5.2 Amp hour sealed NiMH rechargeable battery pack.
To get the maximum life out of the battery packs, follow these three rules:
1. If the sensors are not in use, charge them.
2. Switch sensors “OFF” during charging.
3. Charge for eleven to thirteen hours, and/or provide an extended charge time
(24 hours or longer) at least once a week.
NOTE: Make sure the main power switch at the rear of the console is left
“ON” and the outlet that supplies power to the aligner is on.
To prevent premature degradation of battery performance, the charger has to replace
125% of the energy that was removed from the battery. It is not necessary to fully
discharge the battery packs before charging. However, it is important they be charged
fully.
Charging information:
To recharge the battery packs when the sensors are not in use, place the wheel adaptor
sensor assemblies on the cabinet storage hanger and leave the main aligner power on.
Connect the charging wire harness, 38-1103-2, to the charging port(s) on the sensor(s).
Any time battery packs are being charged, the charge indicator light on the sensor will be
illuminated.