User's Manual

18 GETTING STARTED
Alternating current.
Earth ground terminal.
Protective conductor terminal.
I ON (supply) condition.
OFF (supply) condition.
RISK of electrical shock.
Stand-by switch.
Not intended for connection to public
telecommunications network.
Specific Precautions/Power Source
North America
The PC aligner is intended to operate from a power
source that will apply 120 VAC (nominal) 50/60 Hz
between the supply conductors of the power cordset.
Other Regions
The PC aligner is intended to operate from a power
source that will apply 230 VAC (nominal) 50/60 Hz
between the supply conductors of the power cordset.
The power supply cordset, supplied with this equipment,
may need modification to allow connection to the power
supply mains. Your Hunter service representative will
install the proper plug for your location.
A protective ground connection, through the
grounding conductor in the power cord, is
essential for safe operation. Use only a power
cord that is in good condition.
FUSING:
To avoid fire hazard, use only the fuse specified
for your product.
EQUIPMENT SERVICE:
This equipment contains no user serviceable
parts. All repairs must be referred to a qualified
Hunter Service Representative.
PROVISIONS FOR LIFTING AND
CARRYING:
No provision has been made for lifting or carrying
this equipment. The unit must be moved by
rolling it on its casters.
Equipment Specifications
Electrical
VOLTAGE: 120/230 volts (nominal)
AMPERAGE: 6/3 amps
WATTAGE: 720 watts
Atmospherics
TEMPERATURE: +32°F to +122°F (0°C to +50°C)
RELATIVE HUMIDITY: Up to 95% Non-condensing
ALTITUDE:
Up to 6000 ft. (1829 m)
Explanation of Symbols
These symbols appear on the equipment.