User's Manual

16 GETTING STARTED
1.3 For Your Safety - Hazard
Definitions
These symbols identify situations that could be
detrimental to your safety and/or cause equipment
damage. Watch for these symbols:
Hazards or unsafe practices, which could result
in minor personal injury or product or property
damage.
Hazards or unsafe practices, which could result
in severe personal injury or death.
Immediate hazards that will result in severe
personal injury or death.
IMPORTANT SAFETY INSTRUCTIONS
Read and follow all caution and warning labels affixed to
your equipment and tools. Misuse of this equipment can
cause personal injury and shorten the life of the aligner.
Always use wheel chocks in front of and behind the left
rear wheel after positioning a vehicle on the rack.
Use caution when jacking the vehicle.
ALWAYS WEAR OSHA APPROVED SAFETY
GLASSES. Eyeglasses that only have impact resistant
lenses are NOT safety glasses.
Wear non-slip safety footwear when performing an
alignment.
Never stand on the aligner.
Do not wear jewelry or loose clothing when performing an
alignment.
Wear proper back support when lifting or removing
wheels.
Do not operate equipment with a damaged cord, or
equipment that has been dropped or damaged, until a
Hunter Service Representative has examined it.
Never use the cord to pull the plug from the outlet. Grasp
plug and pull to disconnect.
If an extension cord is necessary, a cord with a current
rating equal to or more than that of the equipment should
be used. Cords rated for less current than the equipment
may overheat. Care should be taken to arrange the cord
so that it will not be tripped over or pulled.
1.2 System Requirements
WinAlign® software version 14.x is a 64-bit program that
is compatible with only WA Series aligners with 1GB of
RAM or higher running Windows® Vista or Windows® 7.
Required Software that will be installed by the WinAlign
software 14.x Installer:
Microsoft® DirectX® 9.0c or later.