User's Manual

• Compensating Sensors BETA - WS602 Series Wheel Alignment Sensors

3.4 Compensation Recall Mode

If sensor power is temporarily interrupted after compensation, a short-term backup

memory on the sensor may hold compensation values until power is restored. When

power is restored, the sensor will indicate that it has valid compensation values by

illuminating the middle compensation indicator while flashing the two outer compensation

indicators. If the sensor has not been dismounted from the vehicle wheel, the

compensation procedure does not have to be repeated. Compensation can be restored

by unlocking the lock knob and tilting the sensor in either direction until the two outer

indicators stop flashing and stay on. Afterwards, restore the sensor to its original position.

If re-compensation is required, pressing the compensation button twice within four

seconds will retake the first reading for that sensor. Refer to the compensation section for

complete compensation procedure.