User's Manual

User Battery Replacement:
The batteries in the battery pack may be replaced. When replacing, use six rechargeable
2700 mAH AA NiMH batteries. Replace all batteries in the battery pack at the same time,
with the same type of battery.
Remove the six screws securing the assembly. Remove the battery pack top. Replace
individual batteries and reassemble.
The battery pack must be recharged before use.
1.6 Vehicle Preparation
Drive the vehicle onto the alignment lift/rack until the front wheels are centered on the
turnplates.
Install wheel chocks to prevent the vehicle from rolling.
Raise the front and rear axles off the lift/rack. If your lift/rack does not have front and rear
axle jacks, raise the axle on which you will be performing the alignment.
Lower the lift/rack leveling legs if your lift/rack is so equipped, and then lower the lift/rack
onto the legs. If your lift/rack does not have leveling legs, lower the lift/rack onto the
lift/rack locks.
Check and adjust the tire pressure, inspect for unevenly worn or mismatched tires.
Inspect all suspension and steering linkage components for wear or damage. A thorough
inspection is important.
BETA - WS602 Series Wheel Alignment Sensors Getting Started • 9