Manualshelf

User's Manual

ManualsBrandsHunter Engineering ManualsElectronicsHunter Model 146-59-1, Alignment Console RF Remote Control
123456789
2
2. Wireless channels in use will be displayed. Press “Scan Channels” to identify channels that are in use. Select
the desired channel, then select “Set Channel”.
Figure 3.
Set the channel of the remote if necessary as follows.
SECOND DESIGN (146-59-1)
SETTING THE REMOTE CHANNEL
The wireless channel is selected using a set of dip switches on the main board. To set the wireless channel,
remove the four screws securing the back cover of the device, then remove the back cover.
Be careful not to lose the black rubber plug over the data port.
Figure 4.
Remove the batteries from the device, then remove the three screws securing the main board.