User's Manual

Connect the Power Source
■ Refer to the appropriate section below based on your order .
➤ For a battery wand, see “If You Have a Battery Wand ...” below .
➤ For an optional DC power supply, see “If You Have a DC Power Supply...” .
If You Have a Battery Wand ...
Install Batteries Into the Battery W and
NOTE: Hunter Douglas recommends AA alkaline batteries for use with our battery-powered assemblies. These will provide more than one year of
operation, depending on usage. Lithium and rechargeable batteries are not recommended.
■ Squeeze the cap latch to release and
remove the cap.
■ Install the batteries according to the instructions on the battery wand label.
■ Replace the cap.
➤ Align the tab with the end of the wand.
➤ Press the cap on until it latches.
Plug the Power Cable into the Battery W and
■ Connect the power cable (coming from the end of the motor) into the socket on the battery wand.
If You Have a DC Power Supply ...
Connect the Power Supply
■ Plug the power cable from the motor into the extension cable.
■ Plug the other end of the extension cable into the DC power supply .
■ Plug the DC power supply into a standard outlet.
WARNING: Keep cords and small parts out of the reach of children. They can wrap cords around their necks and STRANGLE . They can also put
small parts in their mouths and CHOKE .
WARNING: Electric shock and/or a fire hazard may occur if the DC power supply and cables are not properly installed.
Operate the Assembly
Check the Power Cor d
■ Check to ensure the power cord is not pinched.
Test the Assembly Using the Manual Control Button
Testing the shade with the manual control button will allow you to ensure that
the motor and power source are working correctly .
Press the manual control button to test operation
➤ Press the button to alternately rotate motor, stop, and rotate the other way.
Manual control button