Instructions for PV4 Assembly 23mm Motor 31mm Motor
Connect the Power Source ■ Refer to the appropriate section below based on your order. ➤ For a battery wand, see “If You Have a Battery Wand...” below. ➤ For an optional DC power supply, see “If You Have a DC Power Supply...”. If You Have a Battery Wand... Install Batteries Into the Battery Wand NOTE: Hunter Douglas recommends AA alkaline batteries for use with our battery-powered assemblies. These will provide more than one year of operation, depending on usage.
Test the Assembly Using the Remote Refer to the PowerView™ Remote Guide for more information To link a shade to a remote: 1. 2. 3. 4. Press and hold Stop for six seconds to put remote in program mode. The lights on remote will pulsate to indicate it is in program mode. Press and hold the manual control button on the assembly. While continuing to press the manual button, press Stop on the remote. The motor will rotate slightly to indicate it has been linked to the network.
U.S. Radio Frequency FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FFCC CC Rules.
