User's Manual

INSTALLATION

Mount the Installation Brackets — Outside Mount

Prepare the Installation Brackets

■ Use pliers or heavy duty scissors to remove the top

tabs on the installation brackets.

NOTE: Save these tabs once removed. They may be used as shims, if necessary.

Mount the Installation Brackets

■ Center the headrail over the window opening at the desired height. Use a pencil to lightly

mark each end of the headrail.

➤ Alternatively, measure the width of the headrail and use that width to mark the headrail

end points over the window opening.

■ Mark 2" to 3" from each end of theheadrail.

➤ If more than two installation brackets came with your order, space additional bracket(s)

evenly between the two end brackets and mark their location. Mount into wood

whenever possible.

■ Center the installation brackets or extension brackets on your marks and mark where to drill

the screw holes.

➤ A minimum 1

" ﬂat vertical surface isrequired for the installation brackets. Extension

brackets require 1

➤ The tops of the installation brackets or extension brackets should be at the desired

height. The brackets should be level andaligned.

CAUTION: The rear of the brackets must be ﬂush against a ﬂat mounting surface. Do not

mount brackets oncurved molding.

Tab

Remove Top Tab

Back Cover Bracket

Window Opening

Space Evenly

2" to 3" 2" to 3"

Headrail End Mark Headrail End Mark

Extension

Bracket