User's Manual

INSTALLATION
10
Plug the Power Cable into the Battery Wand
■ From the back of the shade headrail, connect the
power cable (from the motor side) into the socket
on the battery wand.
■ Two-On-One Headrail Shades. Plug in both
cables to the battery wands.
Install the Back Cover
■ If using a back cover, install it into the back cover
brackets,
as shown.
Proceed to “Attach Magnetic Hold-Down Brackets (Optional)” on page14
or “Testing the Shade” on page15.
If You Have a Satellite Battery Pack...
Install the Batteries into the Battery Wand
■ See the instructions on the previous page.
Mount the Satellite Battery Pack
■ Decide where you want to mount the satellite battery pack. A satellite battery pack may be
mounted in any orientation.
■ Mark the screw holes for the wall mount bracket.
■ Drill the screw holes using a
3
/ 32 " drill bit.
■ Remove the backing from the double-sided tape. Press the
bracket into place.
■ Attach the bracket using the screws provided.
Power
Cable
Battery
Wand
Back
Cover
Battery Wand
Wall Mount Bracket