PowerView Hub ® QUICK START GUIDE
When prompted, scan or type the Accessory Setup Code below. Table of Contents Kit Contents. . . . . . . . . . . . . . . . . . 3 Connections. . . . . . . . . . . . . . . . . . 5 Home Automation Integration . . . . . . . 13 Troubleshooting. . . . . . . . . . . . . . . 15 © 2017 Hunter Douglas. All rights reserved. All trademarks used herein are the property of Hunter Douglas or their respective owners.
K IT CON T EN TS E. B. PowerView Hub A. Wireless Router D. C. Repeater Power Supply The PowerView ® Hub interfaces with the PowerView ® App to allow control of Hunter Douglas motorized window coverings from mobile devices. The Hub can also integrate with home automation systems via IP or cloud-to-cloud integration. PowerView ® Hub USB PowerView ® Repeater C. USB Power Supply USB Power Supply Cable Cable (Optional) A. D. B. E. Ethernet Note: Download the PowerView® App.
CON NEC T IONS PowerView Hub Wireless Router Repeater Supply connected wireless router. Connect Hub Power to Internet Connect power to Hub. 1. Connect one end of the USB power cable to the USB power supply. 2. Plug the USB power supply into an AC outlet or power strip. 3. Plug the other end of the USB power cable into the power port on the back of the Hub. Note: During the boot-up process, the Hub’s LED may turn off and on again.
CON NEC T IONS Pairing your Hub with an existing PowerView® Shade Network. If you have already established a PowerView ® Shade Network between a PowerView ® Remote and PowerView shades, you should pair the Hub to the same network. To pair the Hub to the same network, open the PowerView ® App and follow the prompts. The Hub LED will turn to solid BLUE, once the Hub has been paired to the PowerView Shade Network. Distribute Repeater(s) as needed.
CON NEC T IONS Transfer your hub data (if needed). Test signal to Repeater(s). If you have a Gen 1 Hub (above left) on your PowerView ® Shade Network, follow in-app instructions to transfer Hub data to the new PowerView ® Hub. Press and hold the P button on the back of the PowerView ® Hub. The light on each Repeater should blink BLUE. If the Repeater does not blink BLUE, move the Repeater closer to the Hub or pair the Repeater to the correct PowerView ® Shade Network.
CON NEC T IONS Configuring multiple Hubs on one PowerView® Network (Optional). You’re ready to use the PowerView® App. For more information about the setup and use of the PowerView ® App, please visit: hunterdouglas.com/operating-systems/powerview-motorization After a primary Hub has been paired to the PowerView ® Network, each subsequent Hub paired to the same network will automatically be configured as a network access point. Please follow in-app instructions to install secondary Hubs.
HOME AU TOM AT ION IN T EGR AT ION PowerView® Motorization integrates with a variety of leading third-party control systems and devices. To learn more about integration, please contact your local Hunter Douglas dealer or visit: hunterdouglas.
Blinking AMBER Hub is not connected to PowerView ® Shade Network. Solid AMBER Hub is updating firmware from the Internet. Solid BLUE Connected, normal operation. Flashing BLUE Hub is Transmitting command(s) to the PowerView Shade Network. Blank Hub is not connected to power or Hub LED functionality has been switched off. Solid GREEN Hub is configured as a secondary Hub. Problem: Cannot connect to the Hub with the PowerView ® App. • Check for blinking AMBER or solid BLUE on the front of the Hub.
