User's Manual

NOT FOR DISTRIBUTION

PowerView

™

AC motor

Quick Start Guide

— Release Candidate —

2 of 11

 PowerView Hub

 PowerView™ Repeater

 PowerView App

Please see the PowerView Instructional Guides and FAQs at the following URL:

http://www.hunterdouglas.com/operating-systems/powerview-motorization/support

EQUIPMENT

The following equipment is required for single shade or multiple shade network setup:

 One or more PowerView AC motors with roller shade

 PowerView Remote Control

 PowerView Hub (optional)

 PowerView App (optional)

 PowerView Repeater (optional)

INSTALLATION STEPS

1. Initial Setup

a) Mount the factory fresh AC motor and roller shade into an appropriate window opening.

b) Plug the AC motor into the appropriate power source (120V~ or 220V~).

c) On a factory fresh PowerView Remote Control, install batteries.

2. Pairing Motor to a Remote

a) On the Remote, press and hold the STOP button until the LEDs begin to blink.

b) On the Remote, press the Group button that you wish to enable. See the APPENDIX to

disable a Group.

c) On the Motor, press and hold the push button on the Motor head.

d) On the Remote, press and release the OPEN button.

e) The Motor will jog two times after it receives the Group enable message from the Remote.

f) On the Motor, release the push button.

3. Change Motor Direction

a) Be sure no end limits are set on the motor. See the APPENDIX to clear limits, if they are set.

b) Wake up the Remote.

c) On the Motor, press and hold the push button.

d) On the Remote, verify no Group LEDs are on solid.

e) Press and release the STOP button.

f) The motor will jog two times after the motor direction has been changed. If end limits are

already set, the motor will not jog, indicating the motor direction did not change.

g) On the Motor, release the push button.

4. Set Upper Motor Limit

a) Use the Remote Open, Remote Close, Remote Tilt Up, Remote Tilt Down, Push Button, or the

Dry Contact inputs to move the motor to the desired upper limit. Note – when limits are

cleared, the motor responds to Remote Open/Close with a single jog in the appropriate

direction.