User's Manual

9
Copyright © Hunter Douglas Window Fashions All rights reserved.
28 April 2016
Confidential
3.Notice
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop configurations or
co-
location with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID can not be
used on the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product
Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may
be
maintained between the antenna and users. The final end product must be labeled in a visible area with the following:
“Contains FCC ID: UXU1DX”. The grantee's FCC ID can be used only when all FCC compliance requirements are
met.
Manual Information To the End
User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF
module in the user’s manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this
manual.