User's Manual
10
Copyright © Hunter Douglas Window Fashions All rights reserved.
28 April 2016
Confidential
IMPORTANT
NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or co-location with
another transmitter), then the Canada authorization is no longer considered valid and the IC ID can not be used
on the
final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including
the
transmitter) and obtaining a separate Canada authorization.
NOTE
IMPORTANTE:
Dans le cas où ces conditions ne peuvent être satisfaites (par exemple pour certaines configurations
d'ordinateur portable ou de certaines co-localisation avec un autre émetteur), l'autorisation du Canada n'est plus
considéré
comme
valide et l'ID IC ne peut pas être utilisé sur le produit final. Dans ces circonstances,
l'intégrateur OEM sera chargé de réévaluer le produit final (y compris l'émetteur) et l'obtention d'une autorisation
distincte au
Canada.
End Product
Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20
cm
may
be maintained between the antenna and users. The final end product must be labeled in a visible area
with the following: “Contains IC:
7316A-1DX
”.
Plaque signalétique du produit final
Ce module émetteur est autorisé uniquement pour une utilisation dans un dispositif où l'antenne peut être
installée
de
telle sorte qu'une distance de 20cm peut être maintenue entre l'antenne et les utilisateurs. Le
produit final doit
être
étiqueté dans un endroit visible avec l'inscription suivante: "Contient des IC:
7316A-1DX
".
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove
this
RF module in the user’s manual of the end product which integrates this
module.
The end user manual shall include all required regulatory information/warning as show in this manual.
Manuel d'information à l'utilisateur
final
L'intégrateur OEM doit être conscient de ne pas fournir des informations à l'utilisateur final quant à la façon d'installer
ou de supprimer ce module RF dans le manuel de l'utilisateur du produit final qui intègre ce
module.
Le manuel de l'utilisateur final doit inclure toutes les informations réglementaires requises et avertissements comme
indiqué dans ce
manuel.