User's Manual

4. Operation instruction
■Getting started
After finishing all steps above, system is workable, follow below
steps.
a) Ensure the video source output of the camera is OK, and the HD
monitor is power on and switched to connected video input port.
b) Ensure all input, output SDI or HDMI cables are connected.
c) Ensure all antennas are installed, and it is better to keep TX 2
antennas and RX 5 antennas with orthogonal angle each other for
best RF performance.
d) Ensure both the transmitter and receiver installed batteries or DC
input ports connected to outside power sources. Then toggle
power switch of transmitter and receiver to ‘ON’ respectively,
then ‘Power’ screen will be light.
e) Ensure the frequency knobs of transmitter and receiver are set
with the same number, and this will make sure the transmitter and
receiver work with same RF frequency.
f) If the camera is on and video input is OK, TX side ‘video’ screen
will be light.
g) Before RX finished wireless link with TX, the Reciever’s OLED
Screen⑤ is not display; when wireless link is OK, the Reciever’s
OLED Screen⑤will display, and ④ will indicate the received
RF signal strength. If the receiver detects normal wireless video
internally from air interface, then the ⑤ will light. Before that,
if SDI or HDMI video out port of the receiver has HD monitor
connected, it will display an OSD of “Link connecting……” like
below picture.