User's Manual

3. Installation
■Installation details and cautions
 Transmitter side
a) Install 2 Omni-directional and high efficiency antennas to
Transmitter’s SMA male antenna connectors.
b) There are 3 1/4-20 screw nuts in transmitter metal case, which are
located on the bottom. So the user can utilize a 1/4 screw to
ISO518 hot-shoe converter fix the transmitter on camera.
c) The user can also utilize a subsidiary LEMO 2 pin male to
D-Type receptacle power cable to get power input from an
outside power source.
 Receiver side
a) Install 5 pcs Omni-directional and high efficiency antennas to
receiver’s SMA male antenna connectors.
b) The user can utilize a subsidiary LEMO 2 pin-male to D-Type
receptacle power cable to get power input from an outside power
source.
c) The user can also utilize the Battery plate accessory Sony U-39 or
Sony NP-970 to connect the power source.
 Typical connection instruction
Connect camera SDI or HDMI output to transmitter SDI or HDMI
input port, and the transmitter can fixed in hot-shoe port of the camera.
Connect HDMI or SDI output port of the receiver to SDI or HDMI input
port of the HD monitor. Make sure all antennas, batteries and Video cable
are equipped normally.