Operation Manual

3
SCP110 Course Computer
Review the following information to choose a mounting location for the Course Computer:
• Fasten the SCP110 Course Computer to a vertical or a horizontal surface, far away from
direct heating, vibrations, and shocks. Places like engine-room, bilge area, or other similar
locations should be avoided.
• If the vessel is provided with a reversing electro-hydraulic actuator, it is necessary to
position the Course Computer in a well-ventilated room. In fact, according to the power
required by the actuator, it is normal that the Course Computer overheats considerably.
• Install the Course Computer far from radio aerials (a few meters are enough) to avoid
interference.
• We also recommend installing it in a place that is easily accessible for technician service
or future installation of optional devices.
SCP110 Course Computer Electronic Card
This Course Computer has a built-in rate gyro (Gyronav). This sensor is wired to a connector
to allow the Course Computer to be mounted on a vertical or horizontal surface. See the
following pages in this section for details.