Owner Manual

Humidex
10
Fasten Unit to the Wall
Now that the flex is tight, it can be
attached to the elbow with the tie wrap.
Flex should not be kinked in any way.
Leaving a 1-inch gap between the top of
the unit and the ceiling (In case of a
finished ceiling, leave a 1/8-inch gap
between the top of the unit and the
ceiling avoiding any contact between the
two) drill ¼” pilot holes through the lips
of the unit and the wall.
Apply the four plastics anchors on the
wall with the help of a hammer. Secure
the Humidex to the wall using the four 1
¼ inch screws provided.
Once the unit is properly installed, return
outside, apply exterior caulking, to the
vent, to act as a weather seal.
NOTE: If high winds are often present
in the location of the vent, they may
cause a wind noise inside the house. If
this is the case, an anti-gust hood
(AGH-990) is available from your
Humidex dealer.
Plug the unit into any 115V outlet.
Note: A grounded extension cord with a maximum length of 10 feet may be
used if necessary.