Full Product Manual

Humidex

Attaching the Flex and Outside Vent

Roll the flat metal plate into a cylinder and interlock both

ends.

Attach the vent to the newly formed 6” pipe with the ½ inch

screws provided.

From the outside, pull the flex pipe through the 6 ¼” hole

onto the 6” pipe and attach it with a 24” cable tie.

Insert four 2-inch screws to secure the vent to the outside

wall. Make sure the vent is not twisted by inserting the screws

too tight and that the flaps are working properly.

NOTE: If high winds are often present in the location of the vent, they may cause a wind

noise inside the house. If this is the case, an anti-gust hood (AGH-990) is available from your

Humidex dealer.

Now that the system has been mounted the HCS can be plugged into any 115V outlet.

Note: A grounded extension cord with a maximum length of 10 feet may be used if necessary