ASSEMBLY INSTRUCTION 530C4(3A) NAPOLEON BACK SIDE CHAIR CHAIR BACK OUTBOX FRAME WOODEN SEAT FRONT LEG (LEFT-RIGHT) 1PC 1PC 1PC PCS CBC BOLT JCBCBOLT STOCK WASHER FLAT WASHER M6 x TUMMY M6 x 40MM M6 M6 x 16MM x 2.0MM PCS PCS 10 PCS 10 PCS CS K-CB SCREW WALLET WRENCH 60MM This page lists all the contents included in the box. Please take the time to identify the hardware as well as the individual components to this product.
Put the Chair Back (A) and Box Frame (B) upside down on the soft and smooth surface. With assistance attach Box Frame (B) (make sure Arrow sticker is facing upward) onto Chair Back (A). Then insert Jibe Bolt (E), Lock Washer (G) and Flat Washer (H) into prevailed holes of each corner by using Allen Wrench (J). Insert Jibe Bolt (F), Lock Washer (G) and Flat Washer (H) into the prevailed holes of the middle of Chair Back (A), by using Allen Wrench (J). Do not fully tighten the bolts in this step.
Attach Wooden Seat (C) and Box Frame (B) with Cs-Cb Screw (1) by using Screwdriver {not included). Tighten all the screws in this step. Stand chair up on an even surface and check that it is balanced. If there is a slight wobble, apply downward pressure in the corner where a leg is uneven. Keeping pressure in that corner, tighten all bolts. If balanced, apply downward pressure evenly in the center and tighten all bolts. Do not over-tighten beyond hole depth.
