Operation Manual

Before contacting your local service
centre, please read the tips below
carefully. If the problem persists after
completing the following procedure,
please contact your local product
distributor or service centre for further
instructions.
1. The product will not switch on.
Ţ$IFDLUIFNBJOQPXFSDBCMFBOENBLF
sure it is plugged into a suitable power
outlet.
Ţ$IFDLUIBUUIFNBJOTTVQQMZJTTXJUDIFE
on.
Ţ$POOFDUUIFQPXFSDBCMFUPBEJƋFSFOU
power outlet.
2. No picture
Ţ.BLFTVSFUIBUUIFQSPEVDUJTQPXFSFE
on and in operation mode. (Press the
STANDBY button)
Ţ.BLFTVSFUIBUUIF"7DBCMFJTŻSNMZ
connected to the TV.
Ţ.BLFTVSFUIBUUIFBOUFOOBDBCMFJT
properly connected to the product.
Ţ#FTVSFUPBDUJWBUFDIBOOFMTFBSDI
Ţ$IFDLUIFCSJHIUOFTTMFWFMPGUIF57
Ţ$IFDLJGUIFDIBOOFMJTDVSSFOUMZPOBJS
3. Poor picture/sound quality
Ţ.BLFTVSFUIFSFJTOPNPCJMFQIPOFPS
microwave oven near the product.
Ţ,FFQUIFQPXFSDBCMFBOEUIF3'DBCMF
apart from each other.
Note: If the antenna is covered with snow
or the RF is weakened by heavy rain,
the condition of the sound and picture
may temporarily be poor. However, poor
sound and picture quality due to weather
conditions cannot be accepted as a
malfunction of product.
Ţ$IBOHFUIFTBUFMMJUFEJTIGPSBMBSHFS
one as this will increase the signal levels
received.
Ţ3FQMBDFUIF-/#XJUIBMPXFSOPJTF
factor in cases where the noise factor is
too high.
Ţ3FQMBDFUIF-/#XJUIBMPXFSOPJTF
factor in case the noise factor is too high.
Ţ3FQMBDFUIF-/#XJUIBOFXPOFJODBTF
it is damaged or out of order.
Ţ*OTUBMMUIFBOUFOOBJOBOPCTUBDMFGSFF
place.
Ţ$IFDLUIFTJHOBMMFWFMTBOEBEKVTU
your antenna if the level is too low. The
signal level may be aected by weather
conditions.
TROUBLESHOOTING
33