V7 Installation Instructions
INSTALLATION HARDWARE b. Choose the desired hole location for top fastener, ideally 66” to Hardware Kit 68” off the floor. Drill hole and install appropriate fastener. 66 - 68 “ c. Hold Track against the Two-Prong Spanner Wrench 10 mm Flat Wrench Hex Key (2mm) 1b wall and fasten using the appropriate fastener in pre-drilled hole. 4 Standard VESA Bracket Screws 4 Keyboard Tray Screws d. Use level to ensure Track is perfectly plumb. Mark the other 4 mounting hole locations.
Note: Release Handle will not function properly unless cable is evenly distributed throughout the arm. b. Slide Aluminum Bushing into top Slider Assembly (B), ensuring set screw is aligned with the small notch in the mount. Be sure Plastic Washer d. Try Release Handle (B) to sits between Monitor Arm and B ensure it functions properly. Track Mount. Arm should move freely when 2b c. Using the ball end of the B the Release Handle is triggered.
STEP 5: ATTACH MONITOR TO MONITOR ARM CABLE MANAGEMENT a. Route monitor cables a. Attach appropriate VESA bracket to Monitor. starting from Monitor going A to Track. i. Place VESA Bracket in position on back of i. Remove gray arm covers Monitor with Lips (A) on from one side of Monitor the left and right. Attach Arm. Insert monitor cables using 4 Standard VESA into the groove of Monitor Bracket Screws. Arm’s front link.
