I N STA L L ATION INST RU CT I O N S
PA RT S R EQUIR ED A Single QuickStand Lite Parts B C A (1) Lower Arm B (1) Upper Arm C (1) Base D (1) Base Plate E (1) M8 Dynamic Arm Long F (1) Clamp Bracket G (1) VESA Plate H (1) Keyboard Platform I (1) Keyboard Platform Mounting Plate J (1) M12 x 25mm Flat Head Machine Screw K (1) M6 x 20mm Flat Head Machine Screw L (8) M6 x 10mm Flat Head Machine Screw E F P G Q M (4) M4 x 8 mm Pan Head Phillips N (4) M4 x 18 mm Pan Head Phillips O (4) VESA Spacers D I H Additional
ST EP 1 ( IF USING CL A MP MOUNT ) Assemble Base and Clamp • Loosen the two M6x12mm screws on the clamp bracket and remove the clamp foot assembly (fig. A) • Attach the clamp bracket to the base using the M12x25mm countersink screw (fig. B) • Attach the base plate to the base with four M6x10mm countersink screws (fig. C) • Slide the clamp foot assembly back onto the clamp bracket and tighten the two M6x12mm screws (fig.
ST EP 3 Remove Cable Cover • Take off the plastic cable cover from the base and remove the 180° stop screw. ST EP 4 Insert M8 Arm • Place the M8 arm into the socket on the base and re-insert the 180°stop screw. ST EP 5 Prep Lower Arm • Remove the plastic cable cover from the lower arm.
ST EP 6 Attach Keyboard Platform • Attach the keyboard platform to the lower arm using four M6x10mm countersink screws and the included metal plate. ST EP 7 Attach Lower Arm to Base • Remove the 180° stop screw from the M8 arm head. (fig. E) • Place the lower arm with keyboard platform into the M8 arm socket and re-insert the 180° stop screw. (fig.
ST EP 9 Attach Upper Arm • Slide the upper arm assembly down onto the lower arm and secure it with a M6x20mm countersink screw ST EP 10 Attach VESA Plate • Attach the VESA plate to your monitor(s) using four M4x8mm pan head screws. If necessary, use the included plastic spacers and extended screws. ST EP 11 Attach Monitors • Slide the monitor(s) onto the monitor quick release until it snaps into place.
ST EP 12 Adjust Monitor Arm Tension • Adjust the tension of the M8 arm using a 5mm hex key to match the weight of the monitor(s). • Turn clockwise for heavier weights and counterclockwise for lighter weights. ST EP 13 Adjust Keyboard Platform Location • Loosen the clamp feet and reposition the base so that the keyboard platform sits in the desired location, then re-tighten the feet. ST EP 14 Set Keyboard Platform Angle • Lift the release lever on the lower arm (fig.
ST EP 15 Attach Palm Rest • Position the palm rest where desired, then remove the plastic backing and press down to adhere. ST EP 16 Setup Cable Management • Place the keyboard and mouse on the platform and run the cables through the center channel on the arm and through the cable hole. • Attach the lower arm cover (fig.
