Owner's manual

humantouch.com
99
ENGLISH
humantouch.com
8
To keep your product working and looking its best, please follow these simple care guidelines.
care and maintenance
• YourBodySparequiresnoregularmaintenance.
• IftheInfraredSeatlampbulbburnsout,replaceitwiththesparebulbthatcamewithyourunit.AdditionalbulbsareavailablefromHumanTouch.
• Ifthecedarsmellistoostrongduringthefirstfewmonthsofuse,wipingdowntheunitwithadampclothmaydampenthesmell.
• Tocleantheinsideofftheunit,unplugit,thenwipeitcleanusingadampcloth.Donotuseliquidcleanersoraerosolcleaners.
• Usefurniturepolishtocleantheoutsideoftheunit.
• Scratchesandstainscanberemovedusingafine-gradesandpaper;donotsandagainstthegrain.
• WhenmovingtheBodySpa,usetherecessedgripsonthefrontandrearoftheunittoliftit,thenmoveittothenewlocation.
YourBodySpacomeswithathermalcircuitbreakerreset,locatednearthemasterpowerswitchonthebackoftheunit.Shouldyourunit
overheat, it will automatically shut down. After allowing it to cool, press the thermal circuit breaker to return the unit to normal operation.
1. UseaPhillips-headscrewdrivertoremovethescrewoneachsideoftheseatbench(Fig.3).
2. Slide the seat bench forward to remove it (Fig.4).
3. Remove and replace the seat lamp bulb (Fig.5).
4. Slide the seat bench back into place, pushing it firmly toward the back of the BodySpa
until the bracket screw hole lines up with the hold in the wood.
5. Replace the screw on each side of the seat bench to secure it.
To change the seat lamp bulb
Specifications*
OperatingVoltage: AC110-120V,60Hz
Power Consumption: 860 Watts
Dimension: 43”Lx24”Wx30”H
Weight: 115 Lbs.
*Specifications are subject to change without prior notice.
Fig.3
Fig.4 Fig.5
Seat bench
Seat bench
Seat lamp bulb