User's Manual

button to scan and memorize the FM radio stations.
2.Press next track and previous track button once to select the channels you
desired.Press and hold the (+)or(-) button to adjust the volume.
To switch from MP3 mode to FM mode or from FM mode to Bluetooth mode,you
need to press the phone /M button once until the mode you want to play with.
Working in wired headphone mode
This device can be used as a wired headphone. To do this, Plug the 3.5mm cable to
“line in “port and plug the other side to the computer or other music device then
could work as a wired headphone.
While in this mode ,FM /MP3 /Bluetooth and headphone functions will not work.
While you wan to back to Bluetooth mode ,Pull out the aux in cable from the
headphone,then the device will go back to Bluetooth mode.
LED LIGHT FLASHING
if you do not want the led flashing ,Double short press the play/Power button ,the
led light would turn off to save battery,if you want the led flashing on again , ,re-do
the previous action again.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) this device may not cause harmful interference, and 2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.