User's Manual

Page 11
off the battery, you can see the bar code label with this code at the back of the phone. The
code stored in the phone can be displayed by inputting “*#06#” under standby state after
the phone is switched on. All brands of mobile phone worldwide must be printed with this
identification code, and the IMEI code for each phone is globally unique without
repetition with another.
6. Basic operation
Switching on
The phone can be switched on (or off) by holding down the hang-up key. It will
automatically search the network if the SIM card and the phone have no password
protection. After the phone is registered in the network, the network's name will be
displayed on the screen. And now you can make or answer a call.
Your phone remains in a searching state if it fails to find the available network system.
If the screen displays “Insert SIM” after it is on, please switch the phone off by holding
down the Hang-up key, and check whether your SIM card is properly installed.
If a password or PIN code for the phone is required after it is switched on, please input the
correct one, and “*” will be displayed on the screen as the content during the entry, then
press the left soft key for confirmation. After unlocked, the phone will display the name of
the registered network and the signal strength.
Please contact your network provider if you do not know the PIN code.
The default password of the phone is “0000”.
Switching off
To switch off the phone, please press and hold down the hang-up key and after the
switch-off animation is dispalyed on the screen, the phone will be switched off. Please do