User's Manual

Basic operations
Switching on
Pressing and holding the key may switch on the phone. It will automatically search the network if the UIM
card and the phone have no password protection. After the phone is registered in CDMA network, signal will be
displayed at the top left corner of the screen. The phone is now in the standby state and you can make or answer
a call.
Your phone remains in a searching state if it fails to find the available network system.
If the screen displays “No UIM Card” after it is switched on, please switch off the phone by pressing and
holding the key
and check whether your UIM card is properly installed.
If a password or PIN code(if with UIM card) for the phone is required after it is switched on, please input the
correct one, and “*” will be displayed on the screen as the content during the entry, then press the key
for
confirmation. After unlocked, the phone will display the signal strength.
Please contact your network provider if you do not know the PIN code.
Switching off
To switch off the phone, please press and hold the key for 2 seconds and more. When the phone displays
closing prompt, the phone will switch off.
Note: If you switch off the phone directly by taking off the battery, some information to be stored in the UIM card and phone may
possibly get lost, which may cause you inconvenience.
Making a call
Under standby state, input number directly via the keypad. In case of international number, press “0” two times
to input “00” first and then input the complete number. Then press the key
to make the call.
The key
is used for deleting the last digit of the number. Press and hold it to clear all the entry and return
to standby screen.
If you want to make a call to the fixed telephone in other cities, please input long-distance area code.
During dialing, you can hear a ringing tone from the other party and after the call is connected, you can see a
call timer on the screen. If the call fails, possible reasons would be:
 “Line Busy” means the called party is busy or there is no available line in the network.
 “Rejected” means this call is barred, or you have enabled call barring. Please check your security setting.
 If the called party’s phone is power-off or out of service range and is unreachable, the network system
will inform you.
 If the called party is in a conversation, please press the key
and redial after a while.
Page 10