Specifications

深圳市康冠技术有限公司
SHENZHEN KTC TECHNOLOGY CO.,LTD
本文档内容属商业机密，版权属深圳康冠技术有限公司所有。未经允许，任何组织或个人不得以任何形式复制和传播。
16
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
RF warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
Transmitter Module Approval Conditions
Antennas must be installed to provide 20 cm separation distance from the transmitting antenna to the body of
the user during normal operating condition. This device must not be co-located or operating in conjunction with
any other antenna or transmitter.
Only those antennas filed under FCC ID: 2A3MNK-AW7603M1 can be used with this device.
When the module is installed in the final system where the antenna location is less than 20 cm separation
distance to the body of user, additional equipment authorization must be applied.
FCC ID label on the final system must be labeled with "Contains FCC ID: 2A3MNK-AW7603M1 " or "Contains
transmitter module FCC ID: 2A3MNK-AW7603M1 ".
In the user guide, final system integrator must be ensure that there is no instruction provided in the user guide
to install or remove the transmitter module.
The transmitter module must be installed and used in strict accordance with the manufacturer's instructions as
described in the user documentation that comes with the product. This device complies with the following radio
frequency and safety standards.
The host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification. The final host product still requires Part 15 Subpart B
compliance testing with the modular transmitter installed.
The end user manual shall include all required regulatory information/warning as shown in this manual,
include:
This product must be installed and operated with a minimum distance of 20 cm between the radiator and user
body.