User's Manual

Charging Instructions

(1) Automatic Charging：Please place the charging base against the wall, remove all obstacles

1 meter on the left and right and 2 meters in front of it, and then connect the power supply.

When the power is insufficient, robot cleaner will automatically source the recharge seat to

charge; In the selection mode (power on status), press the recharge button on the host

panel, and it will automatically source the recharge base for charging，as shown in Figure 1

and 2.

(2) Manual Charging ： Plug the power adapter directly into the charging port of robot

vacuum cleaner, and connect the other end to the power supply.

Figure 1 Figure 2

Attentions：

A. In order to ensure the maximum efficiency and prolong the life of battery, please use the

original adapter to charge this product. It is recommended to charge it for 6-7 hours for the

first charging.

B. When it is charging, the red indicator on host panel is flashing , and the green indicator is

off, it means the charging is happening; If the green indicator is always on and the red

indicator is off, it means robot cleaner had been fully charged.

C. After robot cleaner is fully charged, please turn it off when it does not need to work. If it is

overcharged or not used for too long time, it is easy for the battery to be broken.

Battery Installation and Disassembly Steps

(1) The battery has been installed well before leaving factory. If it needs to be disassembled,

please do it under the guidance of the manufacturer or customer service.

(2) After the screw is loosened(use a crossing screwdriver), open the cover of battery house

（ As shown in Figure 3 and Figure 4).Put the battery in the slot at right place , and lock the

screw after the cover of battery house is closed.