Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WXT2FM2511
PAGE 3 OF 4
Version 1.0
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm
between the radiator & your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
1. FCC regulations restrict the operation of this device to indoor use only.
2. The operation of this device is prohibited on oil platforms, cars, trains, boats, and aircraft, except that operation of
this device is permitted in large aircraft while flying above 10,000 feet.
3. Operation of transmitters in the 5.925-7.125 GHz band is prohibited for control of or communications with
unmanned aircraft systems.
The device must be professionally installed.
The intended use is generally not for the general public.
It is generally for industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter that is
not normally required.
The user has no access to the connector.
Installation must be controlled.
Installation requires special training.
2.2
This module has been assessed against the following FCC rule parts: CFR 47 FCC Part 15 C (15.247, DTS and DSS)
and CFR 47 FCC Part 15 E (NII). It is applicable to the modular transmitter。
The concrete contents to check are the following three points.
2.3
1.Antenna type is a PIFA with no more than 2 dBi gain at 2.4 GHz, 3 dBi gain at 5GHz and 4 dBi at 6GHz.
2.Should be installed so that the end user cannot modify the antenna
3.Feed line should be designed in 50ohm
Fine tuning of return loss etc. can be performed using a matching network.
The antenna shall not be accessible for modification or change by the end user.
Le contenu concret à vérifier sont les trois points suivants.
1. Une des trois antennes suivantes doit être utilisée.
2. doivent être installés de façon que l'utilisateur final ne peut pas modifier l'antenne
3. La ligne d’alimentation doit être conçue en 50ohm
Le réglage précis de la perte de rendement, etc. peut être effectué en utilisant un réseau correspondant.