Product Specs

Hui Zhou Gaoshengda Technology Co., LTD WXT2FM2511
PAGE 2 OF 4
Version 1.0
NOTICE:
◆please keep this product and accessories attached to the places which children can't touch;
◆do not splash water or other liquid onto this product, otherwise it may cause damage;
◆do not put this product near the heat source or direct sunlight, otherwise it may cause
deformation or malfunction;
◆please keep this product away from flammable or naked flame;
◆please do not repair this product by yourself. Only qualified personnel can be repaired.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install
module.
2.6
The module is limited to installation in mobile application. Host device must be operated a minimum of 20cm
between people.
Here are two types of instruction for RF exposure:
1;The host product which the module installed shall be mobile application.
2; The end user manual shall be provide additional text from the host product manusfacturer to end users, It shall
include FCC compliance statements related to the transmitter or labeling requirements.If RF exposure statements and
use conditions are not provided, then the host product manufacturer is required to take responsibility of the module
through a change in FCC ID (new application).
A separate approval is required for all other operating configurations, including portable configurations with respect to
Part 2.1093 and difference antenna configurations.
2.4
The module complies with FCC Part 15.247 / Part 15.407 and apply for Single module approval.
2.5
Trace antenna designs: Not applicable.
Any deviation(s) from the defined parameters of the antenna trace, as described by the instructions, require that the
host product manufacturer must notify the module grantee that they wish to change the antenna trace design. In this
case, a Class II permissive change application is required to be filed by the grantee, or the host manufacturer can
take responsibility through the change in FCC ID (new application) procedure followed by a Class II permissive
change application.