Integration Guide

Hui Zhou Gaoshengda Technology Co., LTD WXT2AM2101
2.6
The module is limited to installation in mobile application. Host device must be operated a minimum of
20cm between people.
Here are two types of instruction for RF exposure:
1;The host product which the module installed shall be mobile application.
2; The end user manual shall be provide additional text from the host product manusfacturer to end users,
It shall include FCC compliance statements related to the transmitter or labeling requirements.If RF
exposure statements and use conditions are not provided, then the host product manufacturer is required
to take responsibility of the module through a change in FCC ID (new application).
A separate approval is required for all other operating configurations, including portable configurations
with respect to Part 2.1093 and difference antenna configurations.
2.7
About the Antenna:
Antenna type is a PIFA with no more than 3.1 dBi gain at 2.4 GHz, 4.17 dBi gain at 5GHz and 4.7 dBi at
6GHz.
2.8
Please notice that if the FCC identification number is not visible when the module is installed inside the
host device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label shall use the wording: Contains FCC ID: 2AC23-
WXT2F
Please notice that if the ISED Canada certification number is not visible when the module is installed
inside the host device, then the outside of the device into which the module is installed must also display
a label referring to the enclosed module. This exterior label c hall use the wording: Contains IC: 12290A-
WXT2F
2.9
Testing of the host product with all the transmitters installed – referred to as the composite investigation
test- is recommended, to verify that the host product meets all the applicable FCC rules. The radio
spectrum is to be investigated with all the transmitters in the final host product functioning to determine
that no emissions exceed the highest limit permitted for any one individual transmitter as required by
Section 2.947(f). The host manufacturer is responsible to ensure that when their product operates as
intended it does not have any emissions present that are out of compliance that were not present when
the transmitters were tested individually.
If the modular transmitter has been fully tested by the module grantee on the required number of
channels, modulation types, and modes, it should not be necessary for the host installer to re-test all the
available transmitter modes or settings. It is recommended that the host product manufacturer, installing