Operating Instructions

(8) ANALOG CHRONOGRAPHS – TYPE C
Chronograph with minutes and seconds hands and date
Legend
1, 2, 3 – Crown positions
Button A – Start/Stop
Button B– Reset
H – Hour hand
M – Minute hand
S– Second hand
P – Chronograph Minutes hand
Q – Chronograph Seconds hand
K– Date Window
Crown positions:
Position 1 - Normal running position; crown pushed into case.
Position 2 - To set DATE: Rotate crown clockwise.
Position 3 - To set TIME: Rotate crown in either direction.
Settingthe time:
1. Pull crown out to position 3. Watch will stop.
2. Turn crown in either direction to move hands to correct time.
3. Push crown back into position 1.
Settingthe date:
1. Pull crown out to position 2.
2. Turn crown clockwise until the correct date.
IMPORTANT: Never correct date between 9:00 PM and 3:00 AM
when
automatic calendar changes are in progress; doing so could
damage the mechanism.
3. Push crown back into position 1.
Chronograph Functions:
NOTE: After 2 hours of continuous running, the chronograph
stops and resets automatically to save battery.
Measuring Cumulative Times:
To measure the combined time of a series of shorter events:
1. Press pushbutton A to start chronograph.
2. Press pushbutton A to stop chronograph and read
elapsed time.
3. Press pushbutton A to resume measurement.
4. Repeat steps 2 and 3 to add each interval of time.
NOTE: Eachtime you stop chronograph, chronograph hands will
indicate total accumulated time.
5. After final reading, push button Bto reset chronograph
hands.
Measuring SplitTimes:
To take intermediate time readings as an event progresses:
1. Push button A to start timing.
2.Push button Bto stop chronograph and read split time.
NOTE: Chronograph continues to run in background.
3. Push button Bto restart; chronograph hands to catch up with
ongoing event.
4. Repeat steps 2 and 3 to take any additional split times.
5. Push button A to stop chronograph.
6. Push button Bto reset chronograph hands.
Q
FigureA
P
S
M
1 – 2 – 3
B
K
H
A
13