Operating Instructions

5
(3) DUAL-TIME MODELS
With rotating reflector ring, GMT 24-hour hand and date
0, 1, 2, 3
– Crown positions
A – Push (-) button to set dual time
B – Push (+) button to set dual time
H – Hour hand
M – Minute hand
S
– Second hand
F – Dual time hand (24
hrs)
J – 24 hours hand
Z – Time zone crown
Crown Positions:
Position 0 - Crown blocked and pushed into case. Turn
unclockwise to liberate the crown in position 1. Push and
turn clockwise to block the crown into case
Position 1 – Normal running position; crown liberated from the
case.
Position 2 – To set DATE and DUAL TIME: Date setting and
correction of dual time with the pushers.
Position 3 - To set TIME and DUAL TIME: Time setting and rapid
correction of dual time with the pushers
Local time is indicated by the hour H, minute M and second S
hands, while left-mounted Dual time hand indicates dual time
hours.
After changing the battery, before setting the time, check if the
dual time hour hand and 24 hours hand are at «0» (12 o’clock
position). If either the dual time hour hand or the 24 hours hand is
not in the «0» position, reset it/them with the following procedure:
1.
2.
3.
Pull crown out to position 2.
Keep the buttons A & B pressed at the same time for more
than 2 seconds, then release the buttons (dual time hands
move and return to where they were).
Press button A or B to reset the dual time hands to
«0» position.
Button A: dual time hour hand move clockwise.
Button B: 24 hours hand move clockwise.
The dual time hands move quickly if the respective buttons
are kept pressed.
4. Push crown back in to position 1.
To set the local time:
1. Pull crown out to position 3, watch stops.
2. Rotate crown in either direction to move hands to desired time.
3. Push crown back in to position 1; watch restarts, now set to
correct time.
To set the date:
1. Pull crown out to position 2.
2. T
urn the crown counterclockwise to set the date hand.
Do not set the date hand between 9:00pm and 2:00am. The
date hand will not move back by turning the crown clockwise.
3. Push crown back in to position 1; watch restarts, now set to
correct date.
To set the dual time (in short push mode):
1. Crown should be in position 2.
2. Adjust the Dual time hand F
by pushing button A to go back 1
hour per push or by pushing button B to advance 1 hour per
push.
3. Push crown back into position 1; watch restarts, now set to
correct time.
To set the dual time (in long push mode):
1. Crown should be in position 3.
2. Adjust the Dual time hand F
by long pushing button A to go
back until reaching the desired hour or by long pushing button
B to advance until reaching the desired hour.
3. Push crown back into position 1; watch restarts, now set to
correct time.
To set time zone reflector ring:
• Rotate clockwisely or unclockwisely the crown Z to set the
time zone.
1 – 2 – 3
A
Figure A
H
F
Z
S
M
J
B