Manualshelf

Installation Guide

ManualsBrandsHugo&Borg ManualsKitchenLondon 18-in W x 34.5-in H x 24-in D White Door and Drawer Base In-Stock Cabinet
12345678910
9
DISHWASHER GABLES
Measure 27 1/8" over from the cabinet at the front and the back and draw a line on the oor. This will
leave you 24 1/8" between the cabinet side and the start of the ller on the face of the dishwasher
panel. Draw a plumb line on the wall from the oor to the base cabinet line. These lines mark the
position of the inside of the dishwasher gable. Install a ledger board 27 1/8" long below the base
cabinet guideline. The panel is then installed by attaching it to the ledger strip, oor and countertop
with metal L-brackets.
CROWN MOULDING
Crown moulding can be
installed with a variety of
methods, depending on the
application. For Hugo&Borg
"frameless" cabinets, crown
moulding will always have to
be attached to the top of the
cabinet, as shown.
Sub-crown reveal variable
1 1/4"
Variable
1"
Ceiling
APPLIANCES
Today’s appliances are available in all shapes and sizes. Because of this, you must conrm opening sizes
against the spec sheet provided with your paperwork, as well as the manufacturer's specications.
• Standard dishwasher openings are to be 24" wide (unless otherwise specied).
• Standard fridge opening is 36" wide x 72" high (unless otherwise specied).
• Standard range openings are to be 31 1/4" wide between base cabinets (unless otherwise
specied).
• Slide-in ranges: the opening and nished counter height is crucial when dealing with slide-in
ranges. Type of ooring and countertop thickness have to be taken into account. Fillers or
scribe on each side may be required to make sure drawers and doors clear the range.
If base cabinets are set too low or high, the range will not sit ush with the countertop.
Countertop top should be 36" unless otherwise noted.
NOTE: Never attempt to move an appliance on nished ooring. Do not connect or disconnect any
appliance that is hard-wired or connected to a water source. Always ask for help before attempting
to move an appliance, as appliances are often heavy and there is a high risk of personal injury or
property damage if not properly handled.
GENERAL INSTALLATION INFORMATION
• Install all cabinets level and plumb.
• Install bumpers on all door and drawer fronts, especially corner cabinets.
• All cut-outs for piping should be as close to pipes as possible with a clean cutout edge.