Installation Guide

8
BASE AND BASE BLIND CORNER
CABINETS
BB45 L/R (base blind corner) cabinets may be
pulled out from the corner if required and the
room is available.
When installing a base cabinet at a right
angle to a BB45 L/R cabinet you must use a
ller to provide clearance for door and drawer
handles. The ller width required is usually
1 3/4" - 3" depending on the type of pull used
on the cabinets.
Cut the 3" ller to required width. Fasten the
ller to the two adjacent cabinets by drilling
through the side of the cabinet into the ller.
Screw together. Ensure cabinets are square
in corner and attach the unit to the wall. Make
sure all cabinets are plumb and level.
The remaining base cabinets are installed in
the same manner. Using the two C-clamps,
align stiles, drill and screw together. Proceed
around the room making sure all cabinets are
plumb and level, shimming where necessary,
then tighten all screws.
Install the remaining base cabinets by aligning
the front of the cabinet edges. Clamp the
cabinets together and attach using the 1 1/8"
screws. Level the cabinet, adjust as required,
and attach to the wall studs using 2 1/2" screws
through the hanging rail located at the top of
the base cabinet. After inserting the screws
remove the clamps.
Filler
Trim this
side of the
ller to
make it t
#8 x 1 1/2"
screws
BASE CORNER CABINET (BC3636)
Base corner cabinets are placed 6" away from
the wall on both sides, leveled and adjusted
as required. They are secured in place by
cabinets on either side. Counter-sink screws
on BC3636 door handles.
NOTE: the cabinet must have 6" of clearance
from the back of the cabinet to each wall in
order to align properly with the other base
cabinets.
6"
6"
Cabinet is installed
with 6" clearance
space from each
wall
43" - 62"
BB45 L/R
Recommended
void space is 6"