Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Configuring the router 5–5
18. To exit router privileged mode, enter exit at the Router
> prompt.
19. Connect the router to the service provider frame relay
service.
Figure 5-2 and the file that follows are examples of a typical
router configuration.
Figure 5-2 Typical AIReach OS IS–41 gateway network diagram
AIReach Office
System Controller
RELIATEL INC
macro system network
S1
E0
S0
E1
RELIATEL INC
frame relay
DLCI = 500 DLCI = 300
T0001028
RELIATEL INC
router
142.148.254.102
255.255.255.252
142.146.254.17
255.255.255.252
142.146.254.101
255.255.255.252
142.146.254.97
255.255.255.252
IS-41
gateway
142.146.254.98
Acme Corporation
Cisco 1602-R router
Router configuration
example