Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Verifying the System Controller configuration 4–19
Verify the MSC Configuration as follows:
1. From the AIReach Office banner menu, select Configure
→ NSS → MSC → MSC Configuration.
2. Click the MSC configuration tab.
The parameters that appear in the MSC Configuration
window depend on whether you selected GW (for gateway)
or SS7 from the IS41 Interface dropdown list in the System
Wide Configuration window.
The screen shown below is for a gateway (GW)
configuration. If you selected SS7 as the IS41 Interface, the
MSC Configuration screen will be different.
3. Select the specified AROSC Name from the dropdown list.
4. Enter or verify the MSC configuration information; then
click Save.
Verifying the MSC
configuration