Installation Instructions

1026209–0001 Revision B 4–18 Verifying the System Controller configuration
6. Click the Service Code tab.
The Service ID should display Emergency. The customer
may provide updated information during the time of
installation.
7. Enter or verify the information; then click Save.
8. Click the IS–41 Timer tab.
9. Enter or verify the information; then click Save.
10. Click the Transport tab.
11. Enter or verify the information for the WOS to Gateway
Server Address and Server Port values; then click Save.
12. Click the Line Range tab.
13. Verify the Line Range values.
14. If you need to modify the Line Range values:
a. Click ADD.
b. Check the Enabled box so you can enter values for
HLR Point Code, mobile phone Begin NpaNxx, and
mobile phone End NpaNxx.
If the AIReach OS is a standalone system, the local
HLR point code is 55 55 229.
If the AIReach OS is connected to a macro system
gateway, enter an invalid but non–zero point code
such as 1 1 1.
c. After entering the correct values, click Save.
15. Click Close to return to the AIReach Office window.