Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Verifying the System Controller configuration 4–11
9. Click the IS136 tab (not shown) to display the AROSC
configuration window.
10. Click the Network Parameters tab.
11. Verify the Service Operator (SOC) and Mobile country
information; then click Accept.
12. Click the Mobile Call Control tab.
13. Verify the information displayed; then click Accept.
14. Click the AROSC Services tab.
15. Verify the information displayed; then click Accept.
16. Click the Call Control tab.
17. Verify the information displayed; then click Accept.
18. Click the Registration Control tab.
19. Verify the information displayed; then click Accept.
20. Click the Timers tab.
21. Verify the information displayed; then click Accept.
Use the scroll bar to view all timers.