Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B 4–8 Verifying the System Controller configuration
16. Select the Frequency Assignment tab.
17. If no channels are listed in the Cluster Frequencies column
(values are channels, not frequencies):
a. For the specified band, enter the start channel in the
left box and the end channel in the right box below
“Specify a frequency or range . . . “
b. Click Enable.
c. Enter AROSC pool size: 30
d. Click Accept.
18. Click the Scanner Parameters tab.
(The screen for this tab is not shown.)
19. Verify or enter the specified values, and click Accept.
20. Close the Cell Configuration – New window.