Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Verifying the System Controller configuration 4–1
Chapter 4
Verifying the System Controller
configuration
After the System Controller has been unpacked, configured with
hardware (cards), and installed, verify the configuration as
explained in the following sections:
• Data required – page 4–2
• Verifying the System Controller configuration – page 4–1
To verify the System Controller configuration, the following data
must be available before you begin:
• Password (administrator level password used to access the
computer)
• IP address for:
- System Controller (or whether DHCP server
assigns it)
- IS–41 gateway
- optional second LAN card, if used
• IS–41 gateway socket number
• DNS (domain name servers) IP addresses
• Subnet mask
• Gateway for the subnet on which the System Controller
resides
• System identification (SID)
• Public system identification (PSID)
• System operator console (SOC)
4.1
Data required