Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision Bvi
3 Installing the Controller 3–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.1 Rack–mount configuration 3–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.2 Mounting the Controller chassis 3–4. . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.3 Controller cabling 3–5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3.4 Checking System Controller operation 3–6. . . . . . . . . . . . . . . . . . . . . . .
3.5 System cabling 3–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4 Verifying the System Controller configuration 4–1. . . . . . . . . . . . . . .
4.1 Data required 4–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
4.2 Verifying the System Controller configuration 4–2. . . . . . . . . . . . . . . . .
Verifying the site information 4–2. . . . . . . . . . . . . . . . . . . . . . . . . . .
Verifying the card information 4–4. . . . . . . . . . . . . . . . . . . . . . . . . . .
Verifying the Network data information 4–9. . . . . . . . . . . . . . . . . . .
Verifying the Cell information 4–12. . . . . . . . . . . . . . . . . . . . . . . . . . .
Verifying the BTS information 4–14. . . . . . . . . . . . . . . . . . . . . . . . . .
Verifying the systemwide configuration 4–17. . . . . . . . . . . . . . . . . . .
Verifying the MSC configuration 4–19. . . . . . . . . . . . . . . . . . . . . . . . .
Configuring the HLR 4–21. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5 Configuring the router 5–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5.1 Installing the router 5–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
5.2 Configuring the router 5–2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Router configuration example 5–5. . . . . . . . . . . . . . . . . . . . . . . . . . .
5.3 Gateway access 5–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6 Testing picocells 6–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.1 Connecting a picocell for testing 6–2. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Providing power to the picocell 6–4. . . . . . . . . . . . . . . . . . . . . . . . . .
6.2 Verifying software load 6–5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.3 Checking scanning picocell operation 6–6. . . . . . . . . . . . . . . . . . . . . . . .
6.4 Performing a test frequency band scan 6–10. . . . . . . . . . . . . . . . . . . . . . .
Switching to Setup mode 6–10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Setting up the frequency band scan 6–11. . . . . . . . . . . . . . . . . . . . . . .
Starting the scan and observing the results 6–13. . . . . . . . . . . . . . . . .
6.5 Checking traffic picocell operation 6–17. . . . . . . . . . . . . . . . . . . . . . . . . .
6.6 Provisioning test mobile phones 6–20. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Subscriber provisioning 6–20. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.7 Programming test mobile phones 6–22. . . . . . . . . . . . . . . . . . . . . . . . . . .
6.8 Registering test mobile phones 6–23. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.9 Placing test calls 6–24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
First transceiver test 6–24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Testing the remaining transceivers 6–25. . . . . . . . . . . . . . . . . . . . . . . .
6.10 Additional phone programming procedures 6–26. . . . . . . . . . . . . . . . . . .
Home system ID 6–26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Home SOC 6–26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PSID/RSID number 6–26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
System ID number 6–26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Operator Code (SOC) 6–27. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .