Installation Instructions

1026209–0001 Revision B 2–30 Adding cards to the System Controller
If you specified a Quad T1 card (in step 9), the software displays
this window, which shows parameters for configuring the Quad T1
card:
11. For each T1 line (Line 1, Line 2 . . . ), verify or select the
following values:
- PC Slot: Slot where the card is installed.
- Connection Type: BTS or PBX. Set according to
whether a BTS or PBX will be connected to the line.
If initially there will be no connection to a line,
select BTS.
- Desired State: INS (in service).
- Line Code: B8ZS.
- Frame Type: ESF.
- Clock Reference: SLAVE, MASTER_EXTERNAL,
or BACKUP.
Set all lines configured as BTS Connection Type to
SLAVE. Set one (and only one) PBX connection on
the Controller to MASTER_EXTERNAL. If a second
PBX connection is present, set it to BACKUP. Set an
other PBX connections to SLAVE.
- T1 Time Slot: All T1 slots should be set to Free.
12. Click Accept to save the information
.
13. After adding cards or modifying any settings under the HW
Config tab, click Start → Shut Down to reboot the
Controller.
Adding a Quad T1 card