Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Adding cards to the System Controller 2–29
6. From the AIReach banner window main menu, select
Configure → BSC Configuration.
7. Click the HW Config tab to display the AROSC
Configuration window shown below.
8. If any installed cards are not listed, click Add to add the
card(s).
9. The AIReach OS software prompts you to enter the type of
card you want to add.
After you enter the appropriate information, the software
displays a configuration window for the type of card you
indicated.
10. To add:
- A Quad T1 card, go to step 11.
- A TX2000 or conference card, go to step 14.