Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Adding cards to the System Controller 2–27
After entering information for new cards (Section 2.8), verify the
card configuration as follows:
1. As the System Controller becomes operational (after
rebooting), several background processes appear on the
Windows taskbar. Verify that the AIReach OS software
applications are present, as indicated on the Windows
taskbar:
The taskbar may show other applications in addition to
those shown here.
(The taskbar is shown vertically here, so the labels can be
read. Typically, it appears horizontally across the bottom of
the screen.)
If any applications are missing, contact your HNS
Installation Manager.
2.9
Verifying the card
configuration