Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B
Adding cards to the System Controller 2–23
After all cards are installed, make sure the MVIP and H.100 bus
ribbon cables are connected to the cards as shown in Figure 2-14.
If you added any cards, connect the bus cables to the added
card(s), as shown.
The MVIP bus ribbon cable connects to:
• The small bus adapter card attached to the top of the first
Quad T1 card (in slot 9)
• Any TX2000 cards
• Any conference cards
The H.100 bus cable connects to all Quad T1 cards.
Make sure the bus adapter card is secure and in full contact
with the (slot 9) Quad T1 card.
Figure 2-14 H.100 and MVIP bus cables (2 views)
LAN 1
card
SBC
card
Conf
card 1
Conf
card 2
TX2000
SS7
card
TX2000
IP
card
SLOT 4
(PCI 7)
SLOT 5
(PCI 6)
SLOT 6
(PCI 5)
SLOT 7
(PCI 4)
SLOT 8
(PCI 3)
SLOT 9
(PCI 2)
SLOT 12 SLOT 13
(ISA 1)
SLOT 14
(ISA 2)
SLOT 15
(ISA 3)
SLOT 16
(ISA 4)
SLOT
10
SLOT
Quad T1 cards
Backplane
Top view
Parallel
port
H.100 bus cable
MVIP bus cable
First
Quad
T1
card
Each rectangle
represents a connector.
H.100 bus cable
MVIP bus cable
(Connects all Quad T1 cards)
(Connects all Tx2000
and conference cards)
Bus adapter
card (slot 9)
T0001029
2.6
Attaching the bus
cables