Installation Instructions
Table Of Contents
- Title page
- Contents
- About this manual
- Safety information
- Ch 1 - Introduction
- Ch 2 - Adding cards to the Controller
- Unpacking the System Controller
- Unpacking the picocells
- System Controller card configuration
- Adding cards to the System Controller (first steps)
- Jumper and DIP switch settings
- Attaching bus cables
- Adding cards to the System Controller (final steps)
- Configuring Controller cards
- Verifying the card configuration
- Ch 3 - Installing the Controller
- Ch 4 - Verifying the Controller configuration
- Ch 5 - Configuring the router
- Ch 6 - Testing picocells
- Ch 7 - Installing picocells
- Ch 8 - Connecting to external equipment
- Ch 9 - System testing
- Ch 10 - Installation inspection
- Ch 11 - Provisioning
- Ch 12 - Remote Client
- Ch 13 - Troubleshooting
- Ch 14 - Maintaining Quad T1 cards
- App A - Specifications
- App B - Standards compliance information
- App C - Part numbers
- App D - Updates and backups
- Index
1026209–0001 Revision B v
Contents
About this manual xi. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Important safety information xv. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1 Introduction 1–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.1 System components 1–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.2 System Controller 1–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hardware 1–3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Software 1–6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.3 Picocell components 1–7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.4 Procedural flow chart 1–8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.5 Tools and materials 1–11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Required tools 1–11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Recommended tools 1–11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Required materials 1–12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Other requirements 1–12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.6 Configuration options 1–12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2 Adding cards to the System Controller 2–1. . . . . . . . . . . . . . . . . . . . .
2.1 Unpacking the picocells 2–4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.2 System Controller card configurations 2–8. . . . . . . . . . . . . . . . . . . . . . .
Backplane slot identification 2–8. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Standard (factory) configuration 2–9. . . . . . . . . . . . . . . . . . . . . . . . .
Fully loaded configuration 2–10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.3 Adding cards to the System Controller (first steps) 2–11. . . . . . . . . . . . .
2.4 Jumper and DIP switch settings 2–13. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Quad T1 card 2–13. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TX2000 IP and TX2000 SS7 cards 2–15. . . . . . . . . . . . . . . . . . . . . . .
Conference card 2–18. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
LAN cards 2–19. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Modem card 2–19. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Single board computer (SBC) 2–20. . . . . . . . . . . . . . . . . . . . . . . . . . .
2.5 Attaching the bus cables 2–23. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
2.6 Adding cards to the System Controller (final steps) 2–24. . . . . . . . . . . . .
2.7 Configuring System Controller cards 2–25. . . . . . . . . . . . . . . . . . . . . . . .
Specifying basic card information 2–25. . . . . . . . . . . . . . . . . . . . . . . .
2.8 Verifying the card configuration 2–27. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adding a Quad T1 card 2–30. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adding a TX2000 or conference card 2–31. . . . . . . . . . . . . . . . . . . . .