Installation Instructions

1026209–0001 Revision B
Adding cards to the System Controller 2–11
In addition to the factory–installed cards listed in Section 2.3, the
Site Configuration Report may specify additional cards:
• Additional Quad T1 cards
(up to 5 additional, for a total of 6)
• A TX2000 SS7 card
• A second conference card
• A second LAN card
If you need to replace, move, or remove a Quad T1 card see
Chapter 14 for important instructions.
To install a card in the System Controller, follow these steps:
1. Make sure the Controller is powered off.
2. Remove the Controller chassis cover, as follows:
a. Loosen the five spring–loaded Phillips head screws at
the rear (top) of the chassis (Figure 2-8).
b. Remove the chassis top cover by lifting the back edge
of the cover (approximately 1 inch) and then sliding
the cover toward the rear of the chassis.
Use care to avoid damaging the copper finger stock under
the front of the cover.
G-17193 F
06/30/99
Copper finger stock
1. Loosen screws
3. Slide cover back
2. Lift cover up
Spring loaded
screws (5)
Figure 2-8 Removing the System Controller cover
2.4
Adding cards to the
System Controller
(first steps)